Skip to content
-
Loosen the shell plate set screw with a 1/8” Allen key.
-
Remove the shell plate bolt using a 1/4" Allen key.
-
Remove the ejector wire and shell plate.
-
Remove the metal detent ball and insert the Teflon ball in its place.
-
Position the shell place back into position.
-
Install the shell plate bearing on the shell plate bolt – first a thrust washer, then the needle bearing, then the remaining thrust washer.
-
Insert the shell plate bolt back into position and snug it down until it stops, then back it out 1/8 of a turn. Check to make sure the shell plate indexes freely. If not, loosen the bolt slightly and re-check. Once set properly, tighten the shell plate set screw and do a final check to make sure the shell plate rotates freely.
-
Replace the ejector wire.
-
Perform a final check to make sure the press operates and cycles properly.
