Skip to content
-
Remove the tool head from the press.
-
Locate the two retainer inserts and insert into them into the casting voids in the tool head where the screws are located. Insert them deep enough so they are flush or slightly below the surface of the tool head and so the slits in the sides of the holes are closest to the light module. You may need to lightly tap the inserts to get them properly positioned.
-
Position the light module over the tool head and align the mounting holes with the inserts.
-
Attach the light module to the tool head using the screws provided.
-
Plug the switch into the light and the power adapter into the switch.
-
Plug in the power adapter and activate the switch to turn on the light.
